Pool Maintenance Planner
Essential planning tools for pool filling, evaporation management, and pump scheduling.
Fill Time Calculator
Typical garden hose: 8-12 GPM
Check your water bill. Average: $0.005/gallon
💡 Tips
- • Fill pool slowly to avoid stress on new plaster
- • Check for leaks during initial fill
- • Add chemicals after pool is full
- • Consider using two hoses to fill faster
Fill Time
Total Time
33h 20m
Total Cost
$100.00
⚠️ Disclaimer: Cost estimates are provided as-is for informational purposes only. Actual costs may vary based on your water provider's rates, seasonal pricing, and usage tiers. Always verify with your local utility provider.
Maintenance Checklists
📅 Weekly Tasks▼
- ✓Test water chemistry (pH, chlorine, alkalinity)
- ✓Skim surface and empty skimmer baskets
- ✓Vacuum pool floor and walls
- ✓Brush walls and tile line
- ✓Check water level and refill if needed
- ✓Inspect equipment for leaks
🌱 Pool Opening▼
- ✓Remove and clean pool cover
- ✓Reinstall ladders, rails, and accessories
- ✓Fill pool to proper level
- ✓Reconnect and start pump/filter
- ✓Test and balance all water chemistry
- ✓Shock pool with chlorine
- ✓Run pump 24 hours, then establish schedule
🍂 Pool Closing▼
- ✓Deep clean pool (vacuum, brush)
- ✓Balance water chemistry
- ✓Shock and add winterizing chemicals
- ✓Lower water level below skimmer
- ✓Drain pump, filter, heater, and chlorinator
- ✓Blow out plumbing lines and add antifreeze
- ✓Remove and store accessories
- ✓Install winter pool cover
Coordinating technician routes? Organize your schedule with OrgFlow — Organizational chart builder to map service teams.